Here's some good news on tiles: the installation will remain essentially the same, no matter what area or room. The bad news is one of the most difficult steps in terms of time, cut. To cut tiles like a pro, take a look at three types of tiles cut by experienced DIY-ers and professionals.
Tools you need: tile cutter, tape measure, wet saw, tile pliers, wire, chips, cards, Sander, markers, paper.
1 Cut the tile mainIf your tiles are cut and measured, cut the main tiles as you go. With a meter to accurately measure the entire area to be covered in order to determine the necessary size of the tiles. Ensure that sufficient space for tiles 1 / 8 "of grout between the tiles. Practice cutting on some scrap before you start. For ceramic tile, tile cutter can be cut with a hand, but also for thicker material (granite) use a wet saw, which can handle the load. When you cut by hand, score the tile once,that is cut very evenly in one motion. Different values are just dull the blade and create jagged edges on the tile. To achieve this cutting aerodynamics, align the arrow on the highlighted line on the cutter. Putting a broken wing, on the underside of the handle, about ½ "or edge of the tile and slowly but firmly push down on the handle to break the wing of the tile. Smoothing the edges with a sanding tiles.
2 Just cut the edge tiles: When you are finishedthe main area, cut the border tiles, the gap between the large tiles and walls or edges to fill. Shaping of the border tiles down, and with a border on the wall or on the board, a sign where to cut - but remember that space filler! Use a marker to replicate the sign on the face tiles. Take the tile cutter and holding it against a ruler, score, on the face in one shot. Take a piece of thin wire and spread on a sheet of particleboard. Align the tile marked over the wire andPrint on both sides to take the tile. If this process is intimidating, or you can cut it with a special card-template for cutting tiles border. After cutting by hand or stencil, use a sander tiles and finish the edges of the plate in all the corners and edges of the round tiled area.
3 Cut the irregular stones: After cutting and laying, and the main border, is the last step to cut the strange form of tiles, appliances, pipes and fittings surrounded. When measuring andInstallation of these tiles is best to get it structured so that the form in which the semi-circle cut from the edges of two adjacent tiles. If this is not possible, mark the center, where an obstacle is cut from the side edges of the tile and draw lines in the face of these points. With a coin or something slightly larger than the diameter of the object, draw a circle around the lines cross. Make a straight cut through the center, then with a tile saw to cut off the other circle. ACut a jagged brick curved shape, use a sheet of thin paper and replicate the exact shape and size needed. Next, align the tiles with the design and cut into small, evenly spaced slits along one side. Transfer the slope of the curve on the face of the tile and then cut with a saw cutter. Use tongs or a micro-tile cutter and then all the edges smooth with a knife in the score. However, if you want to make too many intricate cuts, rent a unit from your dealer, like a diamond diskor puzzles.
We want you to always remember to measure twice and cut once. Although the cut may feel like a brick design, if you have time to take to do each one correctly, the finished product is worth.
For more home improvement tips, visit our site Denver tile system and click through the blog.
0 comments:
Post a Comment